Code No.C2267: Wheel speed signal fail
| caution |
- If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - Troubleshooting
 ).
- Whenever ECU is replaced, ensure that the CAN bus lines are normal.
- When the FCM-ECU is replaced, calibrate the radar (refer to ).
|
OPERATION
The FCM-ECU receives vehicle speed signal from the ASTC-ECU.
DIAGNOSIS CODE SET CONDITIONS
The FCM-ECU sets the diagnosis code when it receives an invalid vehicle speed signal from the ASTC-ECU.
| note |
A diagnosis code is not set as a historic fault.
|
PROBABLE CAUSES
- The CAN bus line is defective.
- ASTC system fault (vehicle speed sensor fault)
- Malfunction of the FCM-ECU
|
|
STEP 1. M.U.T.-III CAN bus diagnosis
|
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
|
Q.
Is the check result normal?
|
|
|
 Go to Step 2.
|
|
|
|
|
|
 Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ). On completion, go to Step 2.
|
|
|
|
|
|
STEP 2. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
|
Check if the diagnosis code is set in the ASTC-ECU (Refer to Diagnosis Code Chart ).
|
|
|
Q.
Is the diagnosis code set?
|
|
|
Troubleshoot the ASTC-ECU diagnosis code (Refer to Diagnosis Code Chart ).
|
|
|
|
|
|
Go to Step 3.
|
|
|
|
|
|
STEP 3. Check whether the diagnosis code is set again.
|
|
|
Check again if the diagnosis code is set in the FCM-ECU.
|
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(4)On completion, check that the diagnosis code is set again.
|
|
|
Q.
Is diagnosis code No. C2267 set?
|
|
|
Replace the FCM-ECU (Refer to ).
|
|
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunctions ).
|
|
|
|