Code No. U0114:
Transfer-ECU CAN Timeout
caution |
- If there is any
problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis,
diagnose the CAN bus lines (Refer to GROUP 54C -
Troubleshooting
).
- If diagnosis code No. U0114 is set in ACC/FCM-ECU, always diagnose the CAN bus line. If
there is any fault in the CAN bus lines, an incorrect diagnosis code may be set. In this case,
the set diagnosis code is not highly reliable.
- Whenever the ECU is replaced, ensure that the CAN bus lines are normal.
- When the ACC/FCM-ECU is replaced, calibrate the radar (refer to
).
|
OPERATION
The ACC/FCM-ECU communicates with the transfer-ECU via the CAN bus lines.
DIAGNOSIS CODE SET CONDITION
The ACC/FCM-ECU receives the 4WD system-related signals from the transfer-ECU via the
CAN bus lines. When these signals cannot be received, the ECU sets this diagnosis code.
PROBABLE CAUSES
- Malfunction of the CAN bus line
- Malfunction of the transfer-ECU
- Malfunction of the ACC/FCM-ECU
|
STEP 1. M.U.T.-III CAN bus diagnostics.
|
|
Use M.U.T.-III to perform the CAN bus diagnosis.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54C -
Troubleshooting ).
On completion, go to Step 2.
|
|
|
|
STEP 2. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
Check if the diagnosis code is set in the transfer-ECU (Refer to GROUP 23A -
Troubleshooting <SS4
II>, Diagnosis Function).
|
|
Q.
Is the diagnosis code set?
|
|
Troubleshoot the transfer-ECU diagnosis code (Refer to GROUP 23A -
Troubleshooting <SS4
II>, Diagnosis Code Chart).
|
|
|
|
Go to Step 3.
|
|
|
|
STEP 3. Use M.U.T.-III to confirm a diagnosis code of other systems.
|
|
Check whether an transfer-ECU "time-out" related diagnosis code is set in other ECUs.
|
|
Q.
Is the diagnosis code set?
|
|
Replace the transfer-ECU (Refer to GROUP 23A -
Transfer-ECU).
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check whether the diagnosis code is set again.
|
|
Check again if the diagnosis code is set in the ACC/FCM-ECU.
|
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(4)Press the FCM and UMS ON/OFF switch to turn the FCM system to ON.
|
|
(5)On completion, check that the diagnosis code is set again.
|
|
Q.
Is diagnosis code No. U0114 set?
|
|
Replace the ACC/FCM-ECU (Refer to ).
|
|
|
|
Intermittent malfunction (Refer to GROUP 00 -
How to Cope with Intermittent
Malfunctions).
|
|
|