REMOVAL AND INSTALLATION <Electric parking brake>


Pre-removal Operation
  • Protector Removal (Refer to ).
  • Shoe and Lever Assembly Removal (Refer to ).

 Post-installation Operation
  • Shoe and Lever Assembly Installation (Refer to ).
  • Protector Installation (Refer to ).
  • Parking Brake Lining Seating Procedure (Refer to ).




Removal steps
<<A>>
·
 Pre-removal operation

>>B<<
 ·
 Post-installation operation
<<B>>
 >>A<<
 1.
 Joint


2.
 Parking brake rear cable

REMOVAL SERVICE POINTS

<<A>> PRE-REMOVAL OPERATION
1.Use the M.U.T.-III to release the parking brake cables fully according to the procedure below:
(1) Move the selector lever to the P position.
(2) Connect the M.U.T.-III and turn ON the ignition switch (Refer to GROUP 00 - Precautions Before Service, M.U.T.-III ).
(3) Check the following actuator test (Refer to ).

  • Item No. 2: Full release control

<<B>> JOINT REMOVAL

Use a flat-tipped screwdriver to disengage the joint tabs, and then remove the joints from the parking brake cables.

INSTALLATION SERVICE POINTS

>>A<< JOINT INSTALLATION
Attach the joints to the parking brake cables, and then use a flat-tipped screwdriver to secure the parking brake cables with the joint tabs.

>>B<< POST-INSTALLATION OPERATION
1.Pull up the electric parking brake switch to apply the parking brake.
Check that the brake warning lamp in the combination meter comes on.
2.Push down the electric parking brake switch to release the parking brake.
Check that the brake warning lamp in the combination meter goes out.