REMOVAL AND INSTALLATION<Lever type parking brake>

Post-installation Operation

Parking Brake Lever Stroke Adjustment (Refer to ).
Parking Brake Lining Seating Procedure (Refer to ).

			Removal steps
<<A>>		·	Rear brake caliper assembly
		·	Rear brake disc
		1.	Shoe-to-anchor spring
		2.	Strut
		3.	Strut-to-shoe spring
		4.	Shoe hold down cup
		5.	Shoe hold down spring
		6.	Shoe hold down cup
		7.	Shoe hold-down pin
		8.	Shoe and lining assembly
	>>B<<	9.	Adjuster assembly
		10.	Adjusting wheel spring
		11.	Shoe hold down cup
		12.	Shoe hold down spring
		13.	Shoe hold down cup
		14.	Shoe hold-down pin
		15.	Shoe and lever assembly
		·	Parking brake rear cable connection
	>>A<<	16.	Retainer
	>>A<<	17.	Shim
		18.	Parking lever
		19.	Shoe and lining assembly
		20.	Shoe guide plate set bolt
		21.	Shoe guide plate

REMOVAL SERVICE POINT

<<A>> REAR BRAKE CALIPER ASSEMBLY REMOVAL

1.Remove the rear brake caliper assembly with brake hose.

2.Hold the rear brake caliper assembly with a wire.

INSTALLATION SERVICE POINTS

>>A<< SHIM / RETAINER INSTALLATION

1.Select an appropriate shim so that the clearance (B) between the parking lever and it reaches 0.1 - 0.35 mm.

2.Crimp the retainer firmly to the pin with pliers.

>>B<< ADJUSTER ASSEMBLY INSTALLATION

Install the adjuster assemblies so that the shoe adjusting bolt is mounted to the rear of the vehicle on the right and left rear wheels at the rear side of the vehicle.

note

For the adjuster assemblies, different parts are used for right and left rear wheels. Install the right-hand screw of the shoe adjusting bolt to the left rear wheel side, and the left-hand screw to the right rear wheel side.