|
If you cannot release the electric
parking brake electrically due to a flat battery, you can
release it manually.
|
|
1.Apply chocks to
wheels.
|
|
2.Move the selector lever to
the "P" position.
|
|
3.Stop the engine if it is
running.
|
|
4.Make sure that the
indicator lamp on the electric parking brake switch is
off.
|
![](../../../img/36/ACF01214AB00ENG.png)
|
5.Remove the protector
(Refer to ). 6.Use
a 4-mm hexagonal bit socket to loosen the three cap mounting
bolts to remove the cap.
|
![](../../../img/36/ACF01215AB00ENG.png)
|
7.Pull out the
plug. 8.Engage the 4-mm hexagonal bit socket with
the plug mount. 9.Push and turn the 4-mm hexagonal
bit socket anticlockwise to loosen the parking brake cables
toward the rear brake to release the parking
brake.
note |
If the parking brake cables
are not loosened any more, the parking brake has
been released completely.
|
|
![](../../../img/36/ACF01215AC00ENG.png)
|
10.Replace the plug, and
then reinstall the plug. 11.Replace the O-ring on
the cap mount, and then reinstall the
cap. 12.Tighten the cap mounting bolts to the
specified torque. Tightening torque: 3.0
± 0.6 N·m 13.Install the
protector (Refer to ).
|