|
1.Raise and support the
front wheels.
|
|
2.Removal the under skid
plate (Refer to GROUP 51 - Under Cover ).
|
![](../../../img/37/ACE02547AC00ENG.png)
![](../../../img/37/ACE02548AD00ENG.png)
|
3.Disconnect the power
steering oil return hose connection (Refer to ), and then
connect a vinyl hose to the power steering oil return hose,
and drain the fluid into a container.
|
![](../../../img/37/AC701885AC00ENG.png)
![](../../../img/37/ACF01018AB00ENG.png)
![](../../../img/37/AC808533AK01ENG.png)
|
4.Disconnect the crank angle
sensor connector.
note |
Doing this will prevent the
engine-ECU from carrying out ignition and fuel
injection.
|
5.While operating the starter motor
intermittently, turn the steering wheel all the way to the
left and right several times to drain all of the
fluid. 6.Connect the return hose securely, and
then secure with the clip. 7.Fill the oil
reservoir with specified fluid up to between "MAX" and "MIN"
marks, and then bleed the air (Refer to ). MITSUBISHI
MOTORS GENUINE PSF (Power Steering Fluid) or DEXRON III,
DEXRON II 8.Connect the crank angle sensor
connector, start the engine, and let it
idle. 9.Installation the under skid plate (Refer
to GROUP 51 - Under Cover ).
|