INSTALLATION SERVICE POINT |
>>A<< STEERING SHAFT JOINT ASSEMBLY/BOLT (STEERING SHAFT LOWER AND STEERING SHAFT JOINT ASSEMBLY CONNECTION)/STEERING SHAFT LOWER/BOLT (STEERING SHAFT JOINT AND POWER STEERING GEAR BOX ASSEMBLY) INSTALLATION |
![]() |
1.Assemble the steering
shaft to the vehicle body as shown. (1) Engage the hole on bracket B with the projection of the bush to install bracket B. (2) Hook the tab of bracket B into the opening on the bracket welded on the spring house. The projection on the bush should be aligned with its corresponding bracket. (3) Hook the opposite tab of bracket B into the opening on bracket A. (4) Tighten the bolt to secure the bush. Tightening torque: 13 ± 2 N·m |
![]() |
2.Align the slit on the
steering shaft assembly with the emboss on the power
steering gear
box assembly. |
![]() |
3.Insert the steering column
bolt into the non-threaded bolt hole, and tighten it to the
specified torque. Tightening torque: 32 ± 3 N·m |
![]() |
|
>>B<< STEERING COLUMN ASSEMBLY INSTALLATION |
|
1.Ensure that the tilt lever
is in the lock position, and install the steering
column. |
![]() |
2.Tighten the bolts in the
following order: (1) Tighten bolt (A) by hand. (2) Tighten bolt (B) by hand. (3) Tighten bolt (C) to the specified torque. Tightening torque: 21 ± 3 N·m (4) Tighten bolt (B) to the specified torque. Tightening torque: 21 ± 3 N·m (5) Tighten bolt (A) to the specified torque. Tightening torque: 42 ± 8 N·m |