REMOVAL AND INSTALLATION

Removal steps 1. Front door inside handle (built-in front door trim) (Refer to GROUP 52A - Door Trim ) · Door waterproof film and door window sash rear Lower (Refer to ) 2. Door outside handle cover 3. Door outside handle 4. Door outside handle gasket 5. Door outside handle base 6. Door latch and cable assembly 7. Screw <<A>> 8. Door latch assembly <<A>> 9. Door lock cover >>B<< 10. Door inside lock cable >>B<< 11. Door inside handle cable 12. Door outside handle rod 13. Door outside lock clip >>A<< 14. Door check

Removal steps 1. Rear door inside handle (built-in rear door trim) (Refer to GROUP 52A - Door Trim ) · Door waterproof film and door window sash rear Lower (Refer to ) 2. Door outside handle cover 3. Door outside handle 4. Door outside handle gasket 5. Door outside handle base 6. Door latch and cable assembly 7. Screw <<A>> 8. Door latch assembly <<A>> 9. Door lock cover >>B<< 10. Door inside lock cable >>B<< 11. Door inside handle cable 12. Door outside handle rod 13. Door outside lock clip >>A<< 14. Door check

Remove the door lock cover in the following procedures: 1.Release the upper and lower claws of the door lock cover by using a flat-tipped screwdriver. 2.Pull the cover out a little. 3.With the cover pulled out state, slide it toward cabled side and remove it from the door latch assembly.

Install the door check with the following identification mark facing upward. Application Identification mark Front door Left door FL Right door FR Rear door Left door RL Right door RR

Connect the door inside lock cable and door inside handle cable to the door inside handle according to the identification colour marked on the cables as shown in the illustration.