DOOR LATCH ASSEMBLY INSPECTION

Check the door lock actuator operation in the following procedures:

1.Open a door that is supposed to be checked.

2.Remove a door trim assembly (Refer to GROUP 52A - Door Trim

3.Use a screwdriver or the like to slide the door latch claw from unlatch to full-latch position (Set the door latch from door-open to door-closed condition).

DOOR LOCK ACTUATOR

ACTUATOR OPERATION CHECK <RH>

Claw position	Door inside handle lock knob position	Battery connection	Door inside handle lock knob operation
Full-latch	Lock	Connect terminal 4 to negative battery terminal. Connect terminal 3 to positive battery terminal.	Knob moves from "Lock" to "Unlock" position.
Full-latch	Unlock	Connect terminal 4 to positive battery terminal. Connect terminal 3 to negative battery terminal.	Knob moves from "Unlock" to "Lock" position.

ACTUATOR OPERATION CHECK <LH>

Claw position	Door inside handle lock knob position	Battery connection	Door inside handle lock knob operation
Full-latch	Lock	Connect terminal 1 to negative battery terminal. Connect terminal 2 to positive battery terminal.	Knob moves from "Lock" to "Unlock" position.
Full-latch	Unlock	Connect terminal 1 to positive battery terminal. Connect terminal 2 to negative battery terminal.	Knob moves from "Unlock" to "Lock" position.

ACTUATOR SWITCH CHECK <RH>

Claw position	Door inside handle lock knob position	Tester connection	Specified condition
Full-latch	Lock	7 - 9	No continuity
Full-latch	Unlock	7 - 9	Continuity exists (2 Ω or less)

ACTUATOR SWITCH CHECK <LH>

Claw position	Door inside handle lock knob position	Tester connection	Specified condition
Full-latch	Lock	6 - 8	No continuity
Full-latch	Unlock	6 - 8	Continuity exists (2 Ω or less)