REMOVAL AND INSTALLATION


Pre-removal operationDoor waterproof film removal (Refer to ).
 Post-installation operation
  • Door window glass adjustment (Refer to ).
  • Door waterproof film installation (Refer to ).
  • Learning procedures of the power window fully closed position (Refer to ).




Removal steps


1.
 Power window main switch (Driver’s side), power window sub switch (Passenger’s side) (Refer to GROUP 52A, Door Trim ).
<<A>>
2.
 Door window glass
<<A>>
3.
 Door window regulator


4.
 Door power window regulator motor




Removal steps


1.
 Power window sub switch (Refer to GROUP 52A, Door Trim .)


·
 Door window sash rear lower (Refer to )
<<A>>
2.
 Door window glass
<<A>>
3.
 Door window regulator


4.
 Door power window regulator motor

REMOVAL SERVICE POINTS

<<A>> DOOR WINDOW GLASS/ DOOR WINDOW REGULATOR REMOVAL
1.Remove the door window glass installation bolts.

2.
caution If tinting film is adhered to the door window glass, attach the special tool window glass holder (MB990480) to the outside of the glass to prevent the film from peeling off.
Lift the door window glass, and attach the special tool window glass holder (MB990480) to the glass as shown to prevent the glass from falling.
3.Remove the door window regulator.