![](../../../img/42/AC103294AA00ENG.png)
|
1.Place an approximately 10
mm thick wood board as shown. Then, close the door window
glass by one-shot up action of the power window
switch. 2.Check that the window glass lowers by
about 150 mm when it clamps the board. This is called
anti-trap function (safety mechanism). If this does not
happen, carry out troubleshooting (Refer to ).
note |
If the anti-trap function
(safety mechanism) is activated consecutively 5
times or more, carry out the learning procedures
of the power window fully closed position (Refer
to .)
|
3.Check that the window glass continue
raising up to the door upmost position without activating
the anti-trap function while the switch is kept pulling up
(this is called forced closing function).
note |
If the battery terminals are
disconnected or the fuse for power window is
removed, carry out the learning procedures of
the power window fully closed position (Refer to
).
|
|