Code No. U1195
Coding not completed
caution |
- If diagnosis
code No. U1195 is set, diagnose the CAN bus lines.
- When replacing the ECU, always check that the communication circuit is normal.
|
DIAGNOSTIC FUNCTION
When the coding data is not registered, KOS&OSS-ECU sets diagnosis code No.U1195.
note |
When KOS&OSS-ECU is new, diagnosis codes No.U1195 are set simultaneously.
|
JUDGEMENT CRITERIA
Check Conditions
- When all the following conditions are met.
- Coding is not completed.
- For 5 seconds since the start of the reception of ignition status signal (ON or
during cranking) transmitted from ETACS-ECU.
Judgement Criterion
- Any of the coding is not completed normally.
PROBABLE CAUSES
- Malfunction of the CAN bus line
- Variant coding for ETACS-ECU has not been implemented.
- Malfunction of KOS&OSS-ECU
- ETACS-ECU malfunction
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting
).
STEP 2. M.U.T.-III other system diagnosis code
Check again if the diagnosis code is set in the ETACS-ECU.
Q.
Is the diagnosis code set?
Diagnose the ETACS-ECU (Refer to GROUP 54A, Troubleshooting
).
Go to Step 3.
STEP 3. Diagnosis code recheck
Check again if the diagnosis code is set in the KOS&OSS-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the engine switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the KOS&OSS-ECU and register the ID codes (Refer to
).
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use
Troubleshooting/Inspection Service Points - How to cope with Intermittent Malfunction
).