DISASSEMBLY AND REASSEMBLY

Disassembly steps 1. Front bumper wiring harness connector connection 2. Front blind spot warning sensor connector connection <Vehicles with blind spot warning system> 3. Front corner clearance sensor connector connection <Vehicles with ultrasonic misacceleration mitigation system> 4. Forward distance warning sensor connector connection <Vehicles with ultrasonic misacceleration mitigation system> 5. Front fog lamp wiring harness <Vehicles with front fog lamp> 6. Front blind spot warning sensor <Vehicles with blind spot warning system> 7. Front blind spot warning sensor bezel <Vehicles with blind spot warning system> 8. Front corner clearance sensor <Vehicles with ultrasonic misacceleration mitigation system> 9. Front corner clearance sensor bezel <Vehicles with ultrasonic misacceleration mitigation system> 10 Forward distance warning sensor <Vehicles with ultrasonic misacceleration mitigation system> 11. Front bumper under grille 12. Front licence plate garnish <Vehicles with licence plate garnish> 13. Front bumper side lower garnish 14. Front bumper side upper garnish <<A>> >>A<< 15. Rivet 16. Front bumper extension 17. Front bumper face

Use a drill (Φ 4.0 mm) to make a hole in the rivet to break it, and remove the rivet.

Use a rivet tool shown as in the illustration to connect the parts with rivets by the following procedures: 1.Insert the rivet into a corresponding location. 2.Set the rivet tool at a portion A of rivet. 3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool. 4.Thin part of portion A of the rivet will be cut off and the part is fixed in position.