![](../../../img/51/ACF00889AB00ENG.png)
|
The windshield wiper motor
assembly should be installed to the vehicle body and the
wiring harness connector should be disconnected when
checking the wiper motor.
|
|
Connect the battery to the
windshield wiper motor to inspect the operation of motor
rotation at low or high speed.
|
|
1.Connect the battery to the
windshield wiper motor as shown in the illustration
(A).
|
|
2.Run the windshield wiper
motor at low speed, then disconnect the battery in the
middle of the motor rotation and check to see that the motor
stops.
|
|
3.Connect the battery to the
windshield wiper motor as shown in the illustration
(B).
|
|
4.Connect the terminals of
the windshield wiper motor connector as shown in the
illustration (B).
|
|
5.Check to see that the
windshield wiper motor runs at low speed and then stops at
the automatic stop position.
|
|
Check the windshield wiper switch
(mist, intermittent, low speed and high speed) from the
ETACS diagnosis codes for proper operations (Refer to GROUP
54A, ETACS ).
|