DISASSEMBLY AND REASSEMBLY

Disassembly steps <<A>> 1. Mirror 2. Connection of blind spot warning wiring harness connector 3. Door mirror outer cover 4. Connection of side turn-signal lamp connector 5. Door mirror base cover 6. Side turn-signal lamp assembly <<B>> 7. Camera cover 8. Connection of camera wiring harness connector <Vehicle with side view camera> 9. Side view camera <Vehicle with side view camera> 10. Camera seaport <Vehicle with side view camera> 11. Actuator <<C>> >>B<< · Tape <<D>> >>A<< 12. Door mirror main wiring harness connector 13. Door mirror base 14. Actuator 15. Rear view mirror retractor motor 16. Body

caution The tab of the mirror is prone to breakage when working in cold temperatures. Always use a hair drier or the like to warm up the mirror tab and its periphery to 20°C or higher prior to works. When the mirror is heated too quickly from its cold state, it may be broken. 1.Slant the mirror upward with your hands. Then insert a flat-tipped screwdriver wrapped with protective tape between the pivot plate and mirror. Now pry off the mirror tabs and release the lower side of the mirror as shown in the illustration. 2.Release the upper side of the mirror tabs while pulling out the mirror. 3.Disconnect the connectors of the heated mirror.

Remove the screw connecting the mirror housing and camera cover.

Remove the tape around the wiring harness shown in the illustration.

Check the wire colour of the wiring harness, and insert it into the connector as shown in the illustration. note Wire colours are indicated by alphabets as shown in the table. Code Wire colour Code Wire colour Code Wire colour Code Wire colour B Black L Blue PU Purple V Violet BR Brown LG Light green R Red W White G Green O Orange SB Sky blue Y Yellow GR Grey P Pink SI Silver BE Beige

Fix the base assembly and the wiring harness at the position of the specified length with a new tape. Tape: Generic products 40 mm width (Colour: Black)