REMOVAL AND INSTALLATION

caution

For the removal of the headlining, refer to GROUP 52B - Service Precautions and Curtain Air Bag Module <Vehicles with curtain air bag>.

Pre-removal and Post-installation Operation

Removal and installation of front pillar trim, centre pillar trim upper, quarter upper trim.
Removal and installation of room lamp assembly (Refer to GROUP 54A - Interior Lamp).

		Removal steps
	1.	Cap <Vehicles with Child Restraint System>
<<A>>	2.	Sunvisor holder
	3.	Sunvisor
	4.	Roof inside assist grip <except for the driver’s side on vehicles without curtain air bag>
	5.	Assist grip clip <Driver’s seat side - except vehicles with curtain air bag>
	6.	Assist grip cover
	7.	Roof inside assist grip
	8.	Roof inside assist grip <7 persons>
	9.	Assist grip clip <5 persons>
	10.	Roof ventilator air outlet <Vehicles with rear cooler>
	11.	Tongue holder lid <Three point type seat belt>
	12.	Harness clip
	13.	Headlining clip
	14.	Sunroof lid inner weather strip rear <Vehicles with sunroof>
<<B>>	15.	Headlining
	16.	Roof sub wiring harness
	17.	Assist grip bracket (Front)
	18.	Assist grip bracket (Centre)
	19.	Assist grip bracket (Rear)
	20.	Tether anchor cover assembly <Vehicles with tether anchor>
	21.	Tether anchor retainer <Vehicles with tether anchor>

REMOVAL SERVICE POINT

<<A>> SUNVISOR HOLDER REMOVAL

Insert the special tools ornament remover (MB990784) into the sunvisor holder from its left and right sides to disengage the claws on the sunvisor holder sides.

<<B>> HEADLINING REMOVAL

To remove the clip, insert a vinyl cord into a clearance between the clip and the headlining, and pass it around the clip. Then, pull out the clip downwards while pulling the vinyl cord.