Code No.U0100
Engine CAN timeout
caution |
- If diagnosis
code No. U0100 is set, be sure to diagnose the CAN bus line.
- When replacing the ECU, always check that the communication circuit is normal.
|
OPERATION
The clearance warning control unit sets diagnosis code No.U0100 when it cannot receive
signals from the engine-ECU.
TROUBLE JUDGEMENT
If the communication with engine-ECU cannot be established for 2500 ms or more.
PROBABLE CAUSES
- Malfunction of CAN bas line
- Malfunction of engine-ECU power supply circuit
- Malfunction of engine-ECU
- Malfunction of clearance warning control unit
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics.
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting
).
STEP 2. Check the M.U.T.-III Diagnosis code for other system.
Check if diagnosis code No. U0100 is set in the combination meter.
Q.
Is the diagnosis code set?
Go to Step 3.
Go to Step 4.
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the engine-ECU (Refer to GROUP 13A - Engine-ECU
<4G6>,
GROUP 13B - Engine-ECU
<6B3> or GROUP
13C - Engine-ECU
<4N1>).
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the clearance warning control unit and the engine-ECU. (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent
Malfunction
.)
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from the "LOCK" (OFF) position to the "ON" position.
|
|
(3)Check if the diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the clearance warning control unit (Refer to
).
A poor connection, open circuit, or other intermittent malfunction in the CAN
bus line between the clearance warning control unit and the engine-ECU. (Refer to GROUP 00 - How
to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent
Malfunction
.)