Code No. C2240
RR side sensor signal lost
OPERATION
The clearance warning control unit sets diagnosis code No.C2240 when it does not receive
any signal from the rear blind spot warning sensor (RH) for at least three seconds.
note |
- If some or all of diagnosis codes C2236 to C2241 are set together with this DTC,
the power supply or earth wires for the sensor may be open-circuited.
- Diagnosis code C2243 will be set instead of this DTC when the sensor power supply
circuit is short to power supply or earth.
|
TROUBLE JUDGEMENT
The condition below is satisfied:
- The rear blind spot warning sensor (RH) does not receive any signal for at
least three seconds.
PROBABLE CAUSES
- Malfunction of rear blind spot warning sensor (RH)
- Malfunction of clearance warning control unit
- Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check of short to earth, and open circuit in PIUS,
SRSR and SIUS line between rear blind spot warning sensor (RH) connector and clearance warning
control unit connector.
note |
To check electric continuity, always select a resistance range of a multimeter.
|
Q.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
STEP 2. Check the rear blind spot warning sensor (RH).
Substitute a known good rear side sensor.
|
(1)Substitute a known good rear side sensor.
|
|
(2)Erase the diagnosis code.
|
|
(3)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(4)The diagnosis code representing the substituted sensor should be set, but diagnosis
code C2240 should not be set.
|
Q.
Is the check result normal?
Replace the rear blind spot warning sensor (RH) (Refer to
).
Go to Step 3.
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the clearance warning control unit.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the clearance warning control unit (Refer to
).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How
to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction
).