Inspection Procedure 4: The image is not switched when the selector lever is moved to the R position.


COMMENT ON TROUBLE SYMPTOM


When the monitor screen is not switched although the selector lever is moved to the "R" position, the selector lever signal system may be defective.

PROBABLE CAUSES



DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics.


Use the M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2.

Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).

STEP 2. Check the operation of the back-up lamp.


Check that the back-up lamp illuminate normally.

Q. Is the check result normal?

Go to Step 3.

Troubleshoot the back-up lamp (Refer to ).

STEP 3. M.U.T.-III data list.


Using the camera-ECU service data.

Item No.
 M.U.T.-III display
 Check condition
 Normal condition
1
 Shift information
 Selector lever: except R position
 Not R
Selector lever: R position
 R

Q. Is the check result normal?

Go to Step 5.

Go to Step 4.

STEP 4. M.U.T.-III other system diagnosis code.


Check whether the A/T system diagnosis codes are set or not.

Q. Is the diagnosis code set?

Diagnose the A/T system (Refer to GROUP 23A - Troubleshooting ).

Go to Step 5.

STEP 5. Retest the system.


Q. Is the check result normal?

The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).

Replace the camera-ECU (Refer to ).