Code No. B2503 Nose view camera fault
TROUBLE JUDGEMENT
If signal from the front-view camera cannot be received for 5 seconds or more, the camera-ECU sets diagnosis code No. B2503.
note |
When diagnosis code No. B2503 is set, the segment, which corresponds to a defective camera, is displayed in blue.
|
PROBABLE CAUSES
- Malfunction of front-view camera
- Malfunction of camera-ECU
- Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Check the wiring harness between front-view camera connector and camera-ECU connector.
Check the following.
- Check of open circuit in ACCN line.
- Check of open circuit in GNDN line.
- Check of open or short circuit in VNV line.
- Check of open circuit in N-EX line.
Q.
Is the check result normal?
Go to Step 2.
Repair the connector(s) or wiring harness.
STEP 2. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the camera-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Go to Step 3.
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction
).
STEP 3. Check the front-view camera.
Use an oscilloscope to check the output waveform of the front-view camera (Refer to
).
Q.
Is the check result normal?
Go to Step 4.
Replace the front-view camera (Refer to
).
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the camera-ECU.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the camera-ECU (Refer to
).
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction
).