Code No.B1A28 ENG ECU authentification error
|
caution |
Whenever the ECU is replaced, ensure that the input and output signal circuits are normal.
|
|
|
ETACS-ECU sets diagnosis code No. B1A28 when the ETACS-ECU’s key certification result and the engine-ECU’s starting condition do not match.
|
|
COMMENT ON TROUBLE SYMPTOM
|
|
ETACS-ECU determines that the abnormality is present, if the key certification result OK but engine-ECU prohibits engine start by immobilizer function or key certification result NG but engine permits engine starts.
|
|
- Malfunction of CAN bus line
- Malfunction of ETACS-ECU
- Malfunction of Engine-ECU
- Chassis number registered in engine-ECU unmatched
|
|
STEP 1. M.U.T.-III CAN bus diagnostics
|
|
Use M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Go to Step 2.
|
|
|
|
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
|
|
|
|
STEP 2. M.U.T.-III other system diagnosis code
|
|
Check whether an engine-ECU diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Perform troubleshooting for the engine (Refer to GROUP 13A - Troubleshooting ).
|
|
|
|
Go to Step 3.
|
|
|
|
STEP 3. Diagnosis code check
|
|
Check if diagnosis code No. B1761 or B2206 is set in the ETACS-ECU.
|
|
Q.
Is the diagnosis code set?
|
|
Perform the troubleshooting of the diagnosis code that has been set.
|
|
|
|
Go to Step 4.
|
|
|
|
STEP 4. Check whether the diagnosis code is set again.
|
|
Recheck if the diagnosis code is set.
|
|
(1)Once key is removed from the ignition cylinder and then turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(2)Check if the diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Replace ETACS-ECU (Refer to ). Then go to Step 5.
|
|
|
|
The diagnosis is complete.
|
|
|
|
STEP 5. Check whether the diagnosis code is set again.
|
|
Recheck if the diagnosis code is set.
|
|
(1)Turn the ignition switch from the LOCK (OFF) position to the ON position.
|
|
(2)Check if the diagnosis code is set.
|
|
Q.
Is the diagnosis code set?
|
|
Replace the engine-ECU and register the chassis number and key codes [Refer to GROUP 00 - How to Perform Chassis Number (Chassis No.) Writing ].
|
|
|
|
The diagnosis is complete.
|
|
|