Code No. U1195: Coding not completed


caution
  • If diagnosis code No. U1195 is set, diagnose the CAN bus lines.
  • When replacing the ECU, always check that the communication circuit is normal.

TROUBLE JUDGEMENT


If the vehicle information data is not registered to the combination meter, the multivision display sets diagnosis code No. U1195.

JUDGEMENT CRITERIA


With the global coding counter value "0," if all the global coding data (vehicle information) are not set, the multivision display determines that a problem has occurred.

PROBABLE CAUSES



DIAGNOSIS PROCEDURE


STEP 1. M.U.T.-III CAN bus diagnostics


Use the M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?

Go to Step 2.

Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).

STEP 2. M.U.T.-III other system diagnosis code


Check if diagnosis code is set in the ETACS-ECU.

Q. Is the diagnosis code set?

Troubleshoot the ETACS-ECU.

Go to Step 3.

STEP 3. Check whether the diagnosis code is set again.


Check again if the diagnosis code is set in the multivision display.
(1)Erase the diagnosis code.
(2)Turn the ignition switch to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?

Replace the gateway-ECU (for smartphone link display audio) (Refer to ) and then go to Step 4.

The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction).

STEP 4. Check whether the diagnosis code is set again.


Check again if the diagnosis code is set in the multivision display.
(1)Erase the diagnosis code.
(2)Turn the ignition switch to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?

Replace the multivision display (Refer to ).

The procedure is complete.