HOW TO READ DIAGNOSIS CODE |
| Use the M.U.T.-III to read diagnosis code (Refer to GROUP 00 - Diagnosis Function). |
HOW TO ERASING DIAGNOSIS CODE |
| Use the M.U.T.-III to erasing diagnosis code (Refer to GROUP 00 - Diagnosis Function). |
CHECK OF FREEZE FRAME DATA |
| To detect fault and set the diagnosis code, the e-Call control unit obtains data before
the confirmation of the diagnosis code and data when the diagnosis code is confirmed, and then stores
the current condition of the e-Call control unit. By analysing each data from M.U.T.-III, the
troubleshooting can be performed more efficiently. Display items of the freeze frame data are
as follows. |
| Item No. |
Item name |
Data item |
Unit |
| 1 |
Odometer |
Total driving distance after the diagnosis code is generated |
km |
| 2 |
Ignition cycle |
Number of times the ignition switch is turned "ON" or "LOCK (OFF)"
after the past failure transition. |
Number of counts is displayed. |
| 4 |
Accumulated minute |
Cumulative time for current malfunction of diagnosis code |
min |
| Diagnosis code No. |
Inspection item |
e-Call switch lamp (red) |
e-Call switch lamp (green) |
|
| B1852 |
Collision signal connection |
Illuminate*1 |
Flash |
|
| B1853 |
Collision signal communication |
|||
| B1854 |
Tel antenna connection |
Illuminate |
Not |
|
| B1855 |
GPS/GLONASS antenna connection |
Not |
Flash |
|
| B1856 |
e-Call speaker connection |
|||
| B1857 |
Microphone connection |
|||
| B1858 |
e-Call SW connection |
Illuminate or not |
Not |
|
| B1859 |
e-Call SW |
Illuminate |
Flash |
|
| B1860 |
e-Call battery connection |
Not |
Flash |
|
| B1861 |
e-Call battery |
|||
| B1863 |
e-Call ECU fail |
Illuminate or not |
Not |
|
| B1864 |
e-Call relay box connection |
|||
| B210D |
Power supply low voltage |
Not |
Not |
|
| B210E |
Power supply high voltage |
|||
| U0100 |
Engine CAN timeout |
Not |
Flash |
|
| U0151 |
SRS-ABG CAN timeout |
Not |
Flash |
|
| U1195 |
Coding not completed |
Illuminate*2 |
Flash |
|
| note |
|