Code No.B1855:
GPS/GLONASS Antenna Connection
| caution |
- Park the vehicle
in an open area where radio wave is not shielded.
- When replacing the ECU, always check that the communication circuit is normal.
|
DIAGNOSTIC FUNCTION
- If the system detects that the GPS/GLONASS antenna is disconnected
for 5 seconds or more within 20 seconds after the ignition switch is turned ON, the e-Call control
unit sets diagnosis code No. B1855.
- If the system detects that the GPS/GLONASS antenna has been disconnected
consecutively twice in 20 seconds or more after the ignition switch is turned ON, the e-Call control
unit will set diagnosis code No.B1855.
| note |
When diagnosis code No. B1855 is set, the e-Call switch flashes in green.
|
PROBABLE CAUSES
- Damaged wiring harness or connector(s)
- Malfunction of GPS/GLONASS antenna
- Malfunction of e-Call control unit
DIAGNOSIS PROCEDURE
STEP 1. Check the connection of GPS/GLONASS antenna
feeder’s connector and e-Call control unit.
Q.
Is the check result normal?
Go to Step 2
Thoroughly connect the GPS/GLONASS antenna feeder’s connector
and the e-Call control unit.
STEP 2. Check if there is any damage to the GPS/GLONASS antenna
feeder and GPS/GLONASS antenna.
Q.
Is the check result normal?
Go to Step 3
Replace the GPS/GLONASS antenna feeder and GPS/GLONASS antenna.
STEP 3. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the e-Call control unit.
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the GPS/GLONASS antenna (Refer to 
).
Then go to Step 4.
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection
Service Points - How to Cope with Intermittent Malfunction).
STEP 4. Check whether the diagnosis code is set again.
Check again if the diagnosis code is set in the e-Call control unit.
|
|
(1)Erase the diagnosis code.
|
|
|
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
|
|
|
(3)Check if diagnosis code is set.
|
Q.
Is the diagnosis code set?
Replace the e-Call control unit (Refer to ).
The diagnosis is complete.