Inspection Procedure 4: The radio broadcasting can not be received. <Roof antenna>


caution
  • Whenever the multivision display is replaced, ensure that the power supply circuit and the earthing circuit are normal. (Check that the voltage is 10 V or more.)
  • Whenever the multivision display is replaced, select "Select Model" on the dealer mode screen.

COMMENTS ON TROUBLE SYMPTOM


In case of FM/AM radio broadcasting cannot be received., antenna rod, antenna base, antenna feeder cable or multivision display may have a problem.
note The radio wave may not be received if the vehicle is placed in the area which is exposed to a special electric field. Thus, check that the radio broadcasting can be received using the radio of another vehicle before carrying out diagnosis.

PROBABLE CAUSES



DIAGNOSIS PROCEDURE


STEP 1. Check the state of the antenna rod and antenna base.


Q. Is the antenna assembled?

Go to Step 2.

Assemble antenna rod and antenna base.

STEP 2. Check to see if inspections are taking place is an area exposed to special electric fields.


Q. Is the reception area exposed to special electric fields?

Go to Step 3.

Go to Step 4.

STEP 3. Move the vehicle and check the radio.


Move the vehicle to a good reception area that is not exposed to special electric fields.

Q. Is the check result normal?

Diagnosis complete.

Go to Step 4.

STEP 4. Check if there is any damage to the antenna rod, antenna base and antenna feeder cable.


Q. Is the check result normal?

Go to Step 5.

Replace the antenna rod, antenna base and antenna feeder.

STEP 5. Check the connection of the antenna feeder cable and multivision display.


Q. Is the antenna feeder cable plug thoroughly connected to the multivision display?

Go to Step 6.

Thoroughly connect the antenna feeder cable plug and the multivision display.

STEP 6. Check of short or open circuit in ANT+ line between multivision display connector and antenna base connector.


Q. Is the check result normal?

Go to Step 7.

Repair the connector(s) or wiring harness.

STEP 7. Substitute a known good multivision display, and check the trouble symptom.


Q. Is the check result normal?

Replace the multivision display.

Either repair or replace the antenna rod and antenna base.