Inspection Procedure 3: The screen is not normal in the navigation mode. (The own vehicle mark is dislocated.)
caution |
Whenever the multivision display is replaced, ensure that the power supply circuit and the earthing circuit are normal. (Check that the voltage is 10 V or more.)
|
COMMENTS ON TROUBLE SYMPTOM
There is a failure in the wiring harness between the combination meter and the multivision display, the GPS antenna, the respective connector(s), the vehicle speed sensor or the multivision display.
PROBABLE CAUSES
- Malfunctions of GPS antenna
- Malfunctions of multivision display
- Damaged harness wires and connectors
DIAGNOSIS PROCEDURE
STEP 1. Confirmation in MMCS service mode.
Check the items below in the MMCS service mode (Refer to
).
- Perform "Communications & Connection Check" in the MMCS service mode to check that the communication and wire connection with the GPS are in good condition.
- Perform "Vehicle Signal Check", and then check the status of the vehicle speed signal.
- Perform "Sensor Check", and then check the status of the vehicle speed sensor and the gyro sensor.
Q.
Is the check result normal?
YES (OK for all)
: Go to Step 5.
NO (GPS is not OK)
: Go to Step 2.
NO (The vehicle speed sensor is not OK, or vehicle speed pulse does not increase after starting from a standstill)
: Go to Step 3.
NO (Gyro sensor is not OK)
: Go to Step 5.
STEP 2. GPS reception check.
|
(1)Start the multivision display.
|
|
(2)Press the "INFO/SET" button.
|
|
(3)Select "GPS Information".
|
|
(4)Check if the GPS signals are received.
|
Q.
Is the check result normal?
Go to Step 5.
Perform Inspection Procedure 5 "GPS signal cannot be received" (Refer to
), and then go to Step 5.
STEP 3. Check the speedometer.
Check whether the speedometer works normally.
Q.
Is the check result normal?
Go to Step 4.
Diagnose the combination meter. (Refer to Combination meter - Troubleshooting)
STEP 4. Check of short circuit and open circuit in REED line between combination meter and multivision display connector.
Q.
Is the check result normal?
Go to Step 5.
Repair the connector(s) or wiring harness.
STEP 5. Check of the troubles
Drive the vehicle for some time with the GPS signals being received, and check if the own vehicle mark is dislocated.
Q.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction).
Replace the multivision display.