![](../../../img/11/AC802015AB00ENG.png)
|
1.Use special tool flywheel
stopper (MB991883) to secure the inertia
ring. 2.Remove the drive plate bolts.
|
|
1.Apply a small amount of
engine oil to the entire inner diameter of the oil seal
lip.
|
![](../../../img/11/AK600423AB00ENG.png)
|
2.Use special tool oil seal
installer (MB992147) to press-fit the crankshaft rear oil
seal. 3.Press-fit the crankshaft rear oil seal
into the oil seal case assembly to have the
dimension shown in the illustration.
|
|
1.Remove completely old
sealant remaining on the oil seal case and cylinder
block.
|
![](../../../img/11/AK500580AB00ENG.png)
|
2.Apply a continuous bead of
the specified sealant (Φ2.3 ± 0.3 mm) to
the oil seal case mating surface as
shown. Specified sealant: ThreeBond 1207F or
equivalent
note |
Install the oil seal case
immediately applying sealant.
|
3.
caution |
After the installation, until
a sufficient period of
time (one hour or more) elapses, do not apply
the oil or water to the sealant application area
or start the engine.
|
Applying an appropriate amount of engine oil to the
entire circumference of its crankshaft
oil seal rear lip portion, and then set the oil seal case to
the cylinder block and tighten the
mounting bolts to the specified
torque. Tightening torque: 11 ± 1
N·m
|
![](../../../img/11/ACE02811AB00ENG.png)
|
Install the adapter plate in the
direction shown in the illustration.
|
![](../../../img/11/AC802016AB00ENG.png)
|
1.Use special tool flywheel
stopper (MB991883) to secure the inertia ring in the same
manner
as removal.
|
![](../../../img/11/ACE01092AB00ENG.png)
|
2.Tighten the drive plate
bolts to the specified torque in the order shown in the
illustration. Tightening torque: 135 ± 5
N·m
|
![](../../../img/11/AC102329AI00ENG.png)
|
1.Apply a small amount of
engine oil to the outer diameter of special tool crankshaft
front
oil seal guide (MD998383) and install it to the
crankshaft. 2.Apply a small amount of engine oil
to the entire inner diameter of the oil seal
lip. 3.Use special tool crankshaft front oil seal
installer (MD998382) to press-fit the crankshaft
front oil seal.
|
![](../../../img/11/ACE02097AB00ENG.png)
|
1.Clean and then degrease
the front lower case, the crankshaft and the crankshaft
sprocket
B as shown.
note |
Degreasing is necessary to
prevent decrease in the friction between
contacting surfaces.
|
2.Install the crankshaft sprocket B in the
direction shown in the illustration.
|