|
1.Remove the oil drain plug
to drain engine oil (Refer to ).
|
![](../../../img/12/AC904112AC00ENG.png)
|
2.Use special tool oil
filter wrench (MB991396, MB991828) or commercially-available
tool to remove the oil filter. 3.Clean the oil
filter installing surface on the cylinder block
side.
|
![](../../../img/12/AC904113AC00ENG.png)
|
4.Apply a small amount of
engine oil to the new oil filter gasket. 5.For the
specified tightening torque, refer to the caution label
attached on the oil filter. 6.Tighten the oil
filter until the gasket contacts with the installation
surface. 7.In the same manner as removal, use
special tool oil filter wrench (MB991396, MB991828) or
commercially-available tool to tighten the oil filter to the
specified torque. 8.Install the oil drain plug and
refill the engine oil (Refer to ). 9.Rev
the engine a few times, and check to be sure that no engine
oil leaks from the installation section of the oil
filter.
|
|
1.Remove the oil drain plug
to drain engine oil (Refer to ).
|
|
2.Remove the bracket for the
battery wiring harness to ensure working space to gain
access to the oil filter.
|
![](../../../img/12/ACX00395AM01ENG.png)
|
3.Use special tool oil
filter wrench (MH061590) or commercially-available tool to
remove the oil filter. 4.Remove the oil filter
through the right wheel house. 5.Clean the oil
filter installing surface on the cylinder block
side.
|
![](../../../img/12/AC904113AC00ENG.png)
|
6.Apply a small amount of
engine oil to the new oil filter gasket. 7.For the
specified tightening torque, refer to the caution label
attached on the oil filter. 8.Tighten the oil
filter until the gasket contacts with the installation
surface. 9.In the same manner as removal, use
special tool oil filter wrench (MH061590) or
commercially-available tool to tighten the oil filter to the
specified torque. 10.Install the oil drain plug
and refill the engine oil (Refer to ). 11.Rev
the engine a few times, and check to be sure that no engine
oil leaks from the installation section of the oil
filter.
|
|
1.Remove the oil drain plug
to drain engine oil (Refer to ).
|
![](../../../img/12/AC904112AB00ENG.png)
|
2.Use special tool oil
filter wrench (MB991396) or commercially-available tool to
remove the oil filter. 3.Clean the oil filter
installing surface on the cylinder block side.
|
![](../../../img/12/AC904113AC00ENG.png)
|
4.Apply a small amount of
engine oil to the new oil filter gasket. 5.For the
specified tightening torque, refer to the caution label
attached on the oil filter. 6.Tighten the oil
filter until the gasket contacts with the installation
surface. 7.In the same manner as removal, use
special tool oil filter wrench (MB991396) or
commercially-available tool to tighten the oil filter to the
specified torque. 8.Install the oil drain plug and
refill the engine oil (Refer to ). 9.Rev
the engine a few times, and check to be sure that no engine
oil leaks from the installation section of the oil
filter.
|