|
Q.
Is the diagnosis code set?
|
|
Inspection chart for diagnosis code (Refer to ).
|
|
|
|
- Refer to Data List Reference Table
.
- Item 5: Intake air temperature sensor
- Item 6: Engine coolant temperature sensor
- Item 8: Manifold absolute pressure sensor
- Item 10: Air flow sensor
- Item 11: Accelerator pedal position sensor (main)
- Item 12: Accelerator pedal position sensor (sub)
- Item 13: Throttle position sensor (main)
- Item 15: Throttle position sensor (sub)
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value (Refer to Inspection Chart for Diagnosis Code ).
|
|
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Clean throttle body (throttle valve portion) (Refer to ).
|
|
|
|
- Refer to Data List Reference Table
.
- Item AC: Oxygen sensor (front)
- Item AD: Oxygen sensor (rear) <EURO4>
|
|
Q.
Are the check results normal?
|
|
Perform the diagnosis code classified check procedure for the sensor that has shown an abnormal data value (Refer to Inspection Chart for Diagnosis Code ).
|
|
|
|
- Measure engine-ECU terminal voltage.
- Engine: Idle operation after warm-up
- Transmission: Neutral
- Cooling fan: Not operated
- Voltage between terminal ALTG and body earth.
|
|
OK: The voltage increases when the headlamp switch and the rear window defogger switch are turned ON from OFF.
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
Q.
Does the trouble symptom persist?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).
|
|
|
|
- Remove the spark plug and install it to the ignition coil.
- Connect the ignition coil connector.
- Disconnect all injector connectors.
- At the engine start, check each spark plug produces a spark.
|
|
Q.
Is the check result normal?
|
|
Check Inspection Procedure - ignition circuit system (Refer to ).
|
|
|
|
- Check purge control solenoid valve itself (Refer to GROUP 17 - Emission Control - Evaporative Emission Control System - Purge Control Solenoid Valve Check
).
|
|
Q.
Is the check result normal?
|
|
YES <Vehicles without AS&G system> : Go to Step 12.
|
|
|
|
Replace the purge control solenoid valve.
|
|
|
|
- Check each injector for spray condition (Refer to
).
|
|
Q.
Is the check result normal?
|
|
- Check the compression pressure (Refer to GROUP 11A - On-vehicle Service - Compression Pressure Check
).
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Q.
Does the trouble symptom persist?
|