|
1.Remove the air intake hose
from the throttle body.
|
|
2.Turn the ignition switch
to "ON" position.
|
|
3.Make sure that the
throttle valve is open.
|
|
4.Turn the ignition switch
to "OFF" position.
|
![](../../../img/13/ACE01971AB00ENG.png)
|
1.Disconnect the throttle
body assembly connector. 2.Measure resistance
between terminal No. 5 and No. 6 at the throttle valve
control servo connector. Standard value: 0.3
- 100 Ω (at 20 °C)
note |
If the measured resistance
deviates from the standard value, fully close
the throttle valve with your finger more than
five times, then check the result again. If
the throttle valve control serve is not used for
an extended period of time, the resistance may
be increased as a result of internal forming of
oxide film. Therefore, it means that the oxide
film can be removed through a self cleaning
capability of the throttle valve control servo,
if forcibly moved.
|
3.If the resistance deviates from outside the
standard value, replace the throttle body assembly.
|