Code No. U1108: Combination Meter Time-out

caution

If diagnosis code U1108 is set in the engine-ECU surely perform CAN bus line diagnosis.

caution

Replace ECU after certainly confirming that the communication circuits are normal.

TROUBLE JUDGEMENT

Check Condition

The diagnosis code setting enabled signal is received from ETACS-ECU.

Judgement Criterion

The signals cannot be received from combination meter for 0.5 second or more.

FAIL-SAFE AND BACKUP FUNCTION

None

COMMENT ON TROUBLE SYMPTOM

Current malfunction

The failure is possibly caused by malfunction of the harness and connector in CAN bus line between engine-ECU and combination meter, by malfunction in the power supply system of combination meter, in combination meter itself, in engine-ECU.

Past malfunction

Proceed with troubleshooting focusing on malfunction of the harness and connector in CAN bus line between engine-ECU and combination meter and malfunction in the power supply system of combination meter. For diagnosis procedure, refer to how to cope with past malfunctions (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Treat Past Malfunctions

note

In the case of past malfunctions, M.U.T.-III CAN bus line diagnosis cannot detect a malfunction even if there is a malfunction in CAN bus. Therefore, check CAN bus line as in the case of response to intermittent malfunctions (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions

). It is possible to narrow down areas with a high possibility of malfunctions from diagnosis codes output to each ECU that performs CAN communication (Refer to GROUP 54C - Explanation about the M.U.T.-III CAN Bus Diagnostics

PROBABLE CAUSES

Failed of the harness and the connector
Failed combination meter
Failed engine-ECU

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnosis

Using M.U.T.-III, perform CAN bus line diagnosis.

Q. Is the check result normal?

	Go to Step 2.

	Correct CAN bus line (Refer to GROUP 54C - Troubleshooting - CAN Bus Diagnosis Table ), and then go to Step 4.

STEP 2. M.U.T.-III other system diagnosis codes

Confirm whether the diagnosis codes are set in the combination meter.

Q. Is the diagnosis code set?

	Perform the troubleshooting of combination meter (Refer to GROUP 54A - Combination Meter - Diagnosis Code Chart ).

	Go to Step 3.

STEP 3. M.U.T.-III diagnosis code

Check that the other ECU performing CAN communication with combination meter sets diagnosis code No. U1108 (Refer to GROUP 54C - CAN communication-related Diagnosis Code Table

Q. Is the diagnosis code set?

	Go to Step 4.

	Go to Step 5.

STEP 4. M.U.T.-III diagnosis code

Reconfirm whether the diagnosis codes are set in the engine-ECU

Erase the diagnosis codes being set.
Ignition switch: "LOCK" (OFF) to ON
Confirm whether the diagnosis codes are set.

Q. Is the diagnosis code set?

	Replace the engine-ECU

	Intermittent malfunction in CAN bus line between engine-ECU and combination meter (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

STEP 5. M.U.T.-III diagnosis code

Reconfirm whether the diagnosis codes are set in the engine-ECU.

Erase the diagnosis codes being set.
Ignition switch: "LOCK" (OFF) to ON
Confirm whether the diagnosis codes are set.

Q. Is the diagnosis code set?

	Go to Step 1.

	The check is end.