|
Check the following points; replace the part if a problem
is found.
|
|
1.Check for damage or cracking of any part.
|
|
2.Using a straight edge and a feeler gauge, check for distortion of the cylinder head
installation surface.
Standard value: 0.5 mm or less Limit: 0.7 mm
|
|
1.Check for damage or cracking of any part.
|
|
2.Using a straight edge and a feeler gauge, check for distortion of the cylinder head
or turbocharger side installation surface.
<Cylinder head side>
Standard value: 0.15 mm Limit: 0.7 mm
<Turbocharger side>
Standard value: 0.1 mm Limit: 0.5 mm
|