|
1.Disconnect the glow plug
relay connector and terminal (Refer to ).
|
![](../../../img/16/ACG02276AB00ENG.png)
|
2.Measure resistance between
terminal C and terminal E. Standard value: 18
- 22 Ω (at
20°C) 3.
caution |
- Always be sure to disconnect the
harnesses
connected to glow plug relay terminals B
and G before using the jumper
cable.
- The terminals of the disconnected
harnesses must not be shorted to
earth.
- When connecting the jumper cable, be
very careful not to make a mistake in
connecting
the terminal, as this will cause damage
to the relay.
|
Use jumper cables to connect terminal C of the glow
plug relay to the battery (+)
terminal and terminal E to the battery (-)
terminal. 4.Check the continuity between glow plug
relay terminals B and G while disconnecting
and connecting the jumper cable at the battery (+)
terminal.
|
Jumper cable at
battery (+)
terminal
|
Continuity between
terminals B and G
|
Connected
|
Continuity (0.01
Ω or less)
|
Disconnected
|
No continuity
(infinite resistance)
|
|
|