|
Item 5: Output shaft speed sensor (Refer to data list reference table ).
|
|
Q.
Is the check result normal?
|
|
Disconnect the connector, and measure the resistance between terminal PGB+ line and PBG- line at the sensor side.
|
|
OK: 560 - 680 Ω (at 20°C)
|
|
Q.
Is the check result normal?
|
|
Disconnect the connector, and measure the resistance between terminal PGB- line and earth at the wiring harness side.
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
Check the shielded wire for any damage.
|
|
Q.
Is the check result normal?
|
|
Repair the wiring harness.
|
|
|
|
Check again if the diagnosis code is set.
|
|
Q.
Is diagnosis code No.P0720 set?
|
|
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
|
|
|
|
(1)Disconnect the connector, and measure the voltage between terminal PGB+ line and earth at the wiring harness side.
|
|
(2)Turn the ignition switch to the ON position. OK: 4.5 - 5.1 V
|
|
Q.
Is the check result normal?
|
|
Q.
Is the check result normal?
|
|
Repair the connector(s) or wiring harness.
|
|
|
|
Check the shielded wire for any damage.
|
|
Q.
Is the check result normal?
|
|
Repair the wiring harness.
|
|
|
|
Remove the output shaft speed sensor. Remove deposits such as foreign material or metal chip from the sensor tip, and check the sensor for damage and any faults.
|
|
Q.
Is the check result normal?
|
|
Replace the output shaft speed sensor.
|
|
|
|
Visually check the parking gear for damage.
|
|
Q.
Is the check result normal?
|
|
Eliminate the cause of the noise.
|
|
|
|
Replace the parking gear.
|
|
|