|
1.Remove the filler plug and
gasket.
|
|
2.Insert an inspection tool
as shown so that it touches the bottom of the filler plug.
The inspection tool: 10 mm-diameter L shaped bar (e.g. 10
mm-diameter angled hexagon wrench).
3.Remove the
inspection tool, and then check that dimension A (between
the bottom edge and the oil level) conforms to the table
below.
|
|
Item
|
Dimension
A
|
Size and number of the
nuts securing the differential
carrier assembly
|
2WD (except High
rider)
|
M8 × 10
|
Within 8 mm
|
2WD (High rider),
4WD
|
M8 × 10
|
Within 8 mm
|
M10 ×
10
|
Within 28 mm
|
M10 ×
12
|
Within 38 mm
|
|
4.Install the filler plug and new gasket,
then tighten them to the specified
torque.
Tightening torque: 50 ± 10
N·m
|
|
1.Remove the filler plug and
gasket.
|
|
2.Insert an inspection tool
as shown so that it touches the bottom of the filler plug.
The inspection tool: 10 mm-diameter L shaped bar (e.g. 10
mm-diameter angled hexagon wrench).
3.Remove the
inspection tool, and then check that dimension A (between
the bottom edge and the oil level) conforms to the table
below.
|
|
Item
|
Dimension
A
|
Size and number of the
nuts securing the differential
carrier assembly
|
2WD (except High
rider)
|
M8 × 10
|
Within 8 mm
|
2WD (High rider),
4WD
|
M8 × 10
|
Within 8 mm
|
M10 ×
10
|
Within 20 mm
|
M10 ×
12
|
Within 30 mm
|
|
4.Install the filler plug and new gasket,
then tighten them to the specified
torque.
Tightening torque: 50 ± 10
N·m
|