|
|
- "Tyre Pressure Sensor ID Registration": To enter the ID into Set 1 when the
TPMS transmitter, ETACS-ECU is replaced.
- "Tyre PRS. Sensor ID Reg.(Set2)": To enter the ID into Set 2 when the TPMS transmitter,
ETACS-ECU is replaced.
|
|
|
1.Select "5tyres ID Reg. (Change tyre PRS.)" and start the tyre pressure sensor ID registration.
|
|
|
2.
| caution |
Register all tyre pressure sensor IDs within 20 minutes.
|
"5 SNSR ID Registration Do you want to start? Note Finish ID Registration within 20 minutes."
is displayed. Then, press "OK."
| note |
If the ID code registration is not finished within 20 minutes, all the ID codes registered
in the TPMS transmitter before will be erased. For this reason, the ID codes need to be registered
again.
|
|
|
|
3.Decrease the tyre pressure to 189 kPa or less <Tyre size: 195R15C 8PR>,
or 204 kPa or less <Tyre size: 205R16C 8PR> by changing 20 kPa or more, and
register the tyre pressure sensor ID code of each wheel to ETACS-ECU.
| note |
- You can start out the operations from any TPMS transmitter. The tyre pressure sensor
ID registration has no order.
- On completion of the tyre pressure sensor ID code registration, the tyre pressure
sensor ID code is displayed on the M.U.T.-III screen.
- M.U.T.-III cannot identify which registered TPMS transmitter is used for each wheel.
For this reason, write down the tyre number for each wheel when the tyre number and ID code
is displayed on the M.U.T.-III during ID code registration.
- It may take approximately 1 minute for the ID code to be displayed on the M.U.T.-III
screen after the tyre pressure is reduced.
- If the ID code is not displayed, reduce the tyre pressure another 20 kPa or more.
If the ID code is not displayed yet, rotate the tyre to displace the TPMS transmitter, and reduce
the tyre pressure 20 kPa or more again.
- If the ID code cannot be registered for all the 4 wheels, the ETACS-ECU may be faulty,
thus replace the ETACS-ECU.
- If the ID code can be registered for 1 wheel or more, the TPMS transmitter in which
the code cannot be registered may be faulty, thus replace that TPMS transmitter.
|
|
|
|
4."5 SNSR ID Registration Completed." is displayed. Then, select "OK."
| note |
The TPMS indicator illuminates for tyre pressure alarm.
|
|
|
|
5.After 1 minute or more has passed, correct the tyre pressure for all wheels with ignition
switch "ON".
|
|
|
6.Check the data list "Registered ID reception, Tyre 1, 2, 3, 4, 5" if "YES" is displayed
for each tyre. When "NO" is displayed, drive the vehicle for approximately 5 minutes, check
the display again. If "NO" is still displayed, register the ID code again.
|
|
|
Follow "TYRE PRESSURE SENSOR ID REGISTRATION".
|