REMOVAL AND INSTALLATION <2WD (High rider), 4WD>


caution
  • *: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.
  • When the suspension is adjusted or replaced, the calibration of steering wheel sensor must be performed. (Refer to GROUP 35C - On-vehicle Service ). <Vehicles with ASTC>
Pre-removal Operation
  • Stabilizer bar (with stabilizer link assembly) removal (Refer to ).
  • Knuckle removal (Refer to GROUP 26 - Front Axle Assembly ).

 Post-installation Operation
  • Knuckle installation (Refer to GROUP 26 - Front Axle Assembly ).
  • Stabilizer bar (with stabilizer link assembly) installation (Refer to ).
  • Check the Dust Cover for Cracks or Damage by pushing it with finger.
  • Front Wheel Alignment Check and Adjustment (Refer to ).




Removal steps


1.
 Lower arm ball joint


2.
 Bolt (Shock absorber and lower arm assembly connection)


3.
 Bump stopper


4.
 Adjust plate
<<A>>
5.
 Lower arm mounting bolt


6.
 Lower arm assembly

REMOVAL SERVICE POINT

<<A>> LOWER ARM MOUNTING BOLT REMOVAL

After making a mating mark on the adjusting bolt, remove the lower arm mounting bolt.