REMOVAL AND INSTALLATION


caution
  • *: Indicates parts which should be temporarily tightened, and then fully tightened with the vehicle on the earth in an unladen condition.
  • When the suspension is adjusted or replaced, the calibration of steering wheel sensor must be performed. (Refer to GROUP 35C - On-vehicle Service ). <Vehicles with ASTC>
Pre-removal Operation
  • Engine Room Under Cover (Refer to GROUP 51, Under Cover ).

 Post-installation Operation
  • Check the Dust Cover for Cracks or Damage by Pushing it with Finger.
  • Engine Room Under Cover (Refer to GROUP 51, Under Cover ).




Removal steps


1.
 Stabilizer clamp

>>A<<
 2.
 Stabilizer bushing


3.
 Stabilizer link assembly and stabilizer bar


4.
 Eye washer


5.
 Stabilizer link assembly


6.
 Stabilizer bar

INSTALLATION SERVICE POINT

>>A<< STABILIZER BUSHING INSTALLATION

Install the bushing with its cut line located as shown in the figure.