REMOVAL AND INSTALLATION


caution When the suspension is adjusted or replaced, the calibration of steering wheel sensor must be performed. (Refer to GROUP 35C - On-vehicle Service).
Pre-removal Operation
  • Engine Room Under Cover (Refer to GROUP 51, Under Cover).

 Post-installation Operation
  • Check the dust cover for cracks or damage by pushing it with a finger.
  • Engine Room Under Cover (Refer to GROUP 51, Under Cover).




Removal steps


1.
 Stabilizer clamp

>>A<<
 2.
 Stabilizer bushing


3.
 Stabilizer link assembly and stabilizer bar


4.
 Stabilizer link assembly


5.
 Stabilizer bar

INSTALLATION SERVICE POINT

>>A<< STABILIZER BUSHING INSTALLATION

Install the bushing with its cut line located as shown in the figure.