LOAD SENSING SPRING LENGTH CHECK AND ADJUSTMENT <VEHICLES WITHOUT ABS>


1.
caution
  • Perform without any parcels placed in the vehicle (in the state of delivery).
  • Do not raise the vehicle using a jack or similar device.
Park the vehicle on a level surface.

2.While pushing the lever in the arrowed direction fully, measure the length A (the length between the both ends of the spring) shown in the figure.
Standard value (A):

    188 - 192 mm <2WD (except High rider)>
    159 - 163 mm <2WD (High rider), 4WD (Vehicles with rear body)>
    155 - 159 mm <2WD (High rider), 4WD (Vehicles without rear body)>
3.If the value is not within the standard value in the item 2, loosen the spring support and adjust to set within the standard value.