REMOVAL AND INSTALLATION <L.H. DRIVE VEHICLES>


Pre-removal Operation
  • Brake Fluid Draining

 Post-installation Operation
  • Brake Fluid Supplying and Air Bleeding (Refer to ).
  • Brake Pedal Adjustment (Refer to ).





Removal steps


1.
 Brake fluid level switch connector


2.
 Brake master cylinder assembly and brake pipe connection

>>B<<
 3.
 Hose clip

>>B<<
 4.
 Vacuum hose (with built-in check valve)


5.
 Harness clip


6.
 Harness bracket


7.
 Fuel pipe bracket <4D5>


8.
 Brake master cylinder assembly

>>A<<
 9.
 Fitting <4G6>


10.
 Hose clip <4D5>


11.
 Vacuum hose <4D5>


12.
 Snap pin


13.
 Clevis pin


14.
 Brake booster mounting nut


15.
 Sealer


16.
 O-ring


17.
 Brake booster assembly

INSTALLATION SERVICE POINTS

>>A<< FITTING INSTALLATION

Apply a sealant as shown.

>>B<< VACUUM HOSE (WITH BUILT-IN CHECK VALVE) AND HOSE CLIP INSTALLATION

<4G6>
  1. Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.
  2. Install the hose clip located as shown in the figure.

<4D5>
  1. Install the vacuum hose (with built-in check valve) with its marking located as shown in the figure.
  2. caution Fit the hose clip as shown, and then allow clearance (C) so that the hose does not touch the EGR valve connector.
    Install the hose clip located as shown in the figure.