REMOVAL AND INSTALLATION


Pre-removal operationBrake Fluid Draining
 Post-installation operationBrake Fluid Supplying and Air Bleeding (Refer to ).





Removal steps


1.
 Eye bolt


2.
 Gasket


3.
 Front brake caliper assembly


·
 Brake disc run-out check and correction (only at installation) (Refer to ).
<<A>>
4.
 Front brake disc


5.
 Connection between brake hose and brake tube

>>A<<
 6.
 Hose clip

>>A<<
 7.
 Brake hose


8.
 Brake hose bracket

REMOVAL SERVICE POINT

<<A>> FRONT BRAKE DISC REMOVAL

If the front brake disc is seized, install a M8 × 1.25 mm bolts as shown, and remove the disc by tightening the bolts evenly and gradually.

INSTALLATION SERVICE POINT

>>A<< BRAKE HOSE AND HOSE CLIP INSTALLATION

<2WD (except High rider)>
    caution Note that the shown marking is only for brake hose <LH>.
    Install the hose clip as shown.


<2WD (High rider), 4WD>
  1. caution Note that the shown marking is only for brake hose <LH>.
    Connect the brake hose so that its fitting faces down.
  2. Install the hose clip as shown.