INSPECTION

Using special tool preload socket (MB991006), rotate the pinion gear at the rate of one rotation in approximately 4 to 6 seconds to check the total pinion torque. Standard value: 0.6 - 1.8 N·m (Torque fluctuation: 0.4 N·m or less) <2WD (Except High rider)> 0.6 - 2.0 N·m (Torque fluctuation: 0.4 N·m or less) <2WD (High rider), 4WD> note When measuring, remove the bellows from the rack housing. Measure the pinion torque through the whole stroke of the rack. If the measured value is not within the standard range, first adjust the rack support cover, and then check the total pinion torque again. If the total pinion torque cannot be adjusted to within the standard range by adjusting the rack support cover, check the rack support cover, rack support spring, rack support and replace any parts if necessary.

2.If the dust cover is cracked or damaged, replace the tie rod end. (Refer to .) note Cracks or damage of the dust cover may damage the ball joint. If it is damaged during service work, replace the tie rod end. (Refer to .)