REMOVAL AND INSTALLATION

Removal steps 1. Power window main switch (driver’s side), power window sub switch (passenger’s side) (Refer to GROUP 52A, Door Trim ). <<A>> >>B<< 2. Clip >>B<< 3. Regulator handle >>B<< 4. Escutcheon · Waterproof film (Refer to ). · Beltline moulding, beltline weatherstrip inner (Refer to ). 5. Door window glass assembly >>A<< · Post-installation operation check <<B>> 6. Door window regulator assembly 7. Power window motor <Vehicles with power window>

Removal steps 1. Power window sub switch (Refer to GROUP 52A, Door Trim .) <<A>> >>B<< 2. Clip >>B<< 3. Regulator handle >>B<< 4. Escutcheon · Beltline moulding, beltline weatherstrip inner (Refer to .) · Waterproof film (Refer to .) 5. Door window glass assembly 6. Door window glass holder >>A<< · Post-installation operation check · Waterproof film (Refer to .) <<B>> 7. Door window regulator assembly 8. Power window motor <Vehicles with power window>

Use a cloth to remove the clip as shown in the illustration.

2. caution If tinting film is adhered to the door window glass, attach the special tool window glass holder (MB990480) to the outside of the glass to prevent the film from peeling off. Lift the door window glass, and attach the special tool window glass holder (MB990480) to the glass as shown to prevent the glass from falling. 3.Remove the door window regulator assembly.

When the following procedures are carried out, make the power window switch learn the fully closed position of the power window (Refer to ).

1.Install the escutcheon and regulator handle to the clip. 2.Close the door window glass fully, and then install the regulator handle as shown in the illustration.