![](../../../img/42/AC103294AA00ENG.png)
|
1.Place an approximately 10
mm thick wood board as shown. Then, close the door window
glass
by one-shot up action of the power window
switch. 2.Check that the window glass lowers by
about 150 mm when it clamps the board. This
is called anti-trap function (safety mechanism). If this
does not happen, carry out troubleshooting
(Refer to ).
note |
If the anti-trap function
(safety mechanism) is activated consecutively 5
times or more,
carry out the learning procedures of the power
window fully closed position (Refer to .)
|
3.Check that the window glass continue
raising up to the door upmost position without
activating the anti-trap function while the switch is kept
pulling up (this is called forced closing
function).
note |
If the battery terminals are
disconnected or the fuse for power window is
removed, carry
out the learning procedures of the power window
fully closed position (Refer to ).
|
|