![](../../../img/51/ACE02775AB00ENG.png)
|
The windshield wiper motor
assembly should be installed to the vehicle body and the
harness
connector should be disconnected when checking the wiper
motor.
|
|
Connect the battery to the
windshield wiper motor to inspect the operation of motor
rotation
at low or high speed.
|
|
1.Connect the battery to the
windshield wiper motor as shown in the illustration
(A).
|
|
2.Run the windshield wiper
motor at low speed, then disconnect the battery in the
middle
of the motor rotation and check to see that the motor
stops.
|
|
3.Connect the battery to the
windshield wiper motor as shown in the illustration
(B).
|
|
4.Connect the terminals of
the windshield wiper motor connector as shown in the
illustration
(B).
|
|
5.Check to see that the
windshield wiper motor runs at low speed and then stops at
the
automatic stop position.
|
![](../../../img/51/AC609144AB00ENG.png)
|
Check continuity between the switch
terminals.
|
Switch
position
|
Tester
connection
|
Specified
condition
|
OFF
|
-
|
Open circuit
|
Windshield mist wiper
switch
|
8 -
10
|
Continuity (Less than 2
ohms)
|
Windshield
intermittent wiper switch
<vehicles without auto
lamp> Windshield auto wiper
switch <vehicles with auto
lamp>
|
5-
8
|
Windshield low-speed
wiper switch
|
6 -
8
|
Windshield high-speed
wiper switch
|
4 -
8
|
|
|
|
Check the windshield wiper switch
(mist, intermittent, low speed and high speed) from
the ETACS diagnosis codes for proper operations (Refer to
GROUP 54A, ETACS ).
|