REMOVAL AND INSTALLATION

		1.	Headrestraint
			Removal steps
<<A>>		2.	Rear anchor cover
<<B>>		·	Wiring harness connectors
	>>A<<	3.	Front seat assembly

REMOVAL SERVICE POINT

<<A>> REAR ANCHOR COVER REMOVAL

Disengage the lower tab of the rear anchor cover, and slide the cover rearwards to remove.

<<B>> WIRING HARNESS CONNECTORS DISCONNECTION

Disconnect the following wiring harness connectors:

Connector number	Connector name
E-20 (2 - yellow)	Side air bag module (squib) connector (LH)
E-28 (2 - yellow)	Side air bag module (squib) connector (RH)
E-21 (2)	Front seat belt switch connector (Driver’s side)
E-26 (2)	Front seat belt switch connector (Passenger’s side)
E-23 (2)	Power seat assembly connector (Driver’s side) <Vehicle with power seat>

note

When disconnecting the side air bag module connectors of E6T and F6T, unlock the connector by sliding the locking button to the direction of the arrow as shown in the figure, and then disconnect the connector.

INSTALLATION SERVICE POINT

>>A<< FRONT SEAT ASSEMBLY INSTALLATION

1.Confirm that both the seat slides are locked, and then temporarily tighten all the bolts and nuts shown in the figure so that no load is applied to the front seat cushion.
2.Tighten all the bolts and nuts to the specified torque.
Tightening torque: 43 ± 8 N·m (Bolt)
Tightening torque: 30 ± 5 N·m (Nuts)