|
If any malfunction is found in the
following inspections, replace the air bag module with a new
one.
|
![](../../../img/52/ACB03701AB00ENG.png)
|
- Pad cover dent, crack or deformation
- Check the harness and connector for damage and the
terminal for deformation.
- Check the air bag inflator cases for dents, cracks
or deformation.
- Check the air bag module for proper
installation.
|
|
If any malfunction is found in the
following inspections, replace the clock spring with a new
one.
|
![](../../../img/52/ACD01292AG00ENG.png)
|
1.Check the connectors and
protective tubes for damage and the terminal for
deformation. 2.Check the case for
damage. 3.Check that the continuity exists between
the following connector terminals.
- Clock spring connector terminal 1 and horn connector
terminal 1
- Clock spring connector terminal 5 and horn connector
terminal 5
|
![](../../../img/52/ACD01297AC00ENG.png)
|
4.As shown in the Figure,
connect the circuit tester to special tool extra fine probe
(MB992006) and check to see that there is a charge between
the terminals.
|