|
If only the speedometer does not operate, the combination meter, the wiring harness or
its connector may be defective.
|
|
- Damaged harness wires and connectors
- Malfunction of combination meter
|
|
Use the M.U.T.-III to diagnose the CAN bus lines.
|
|
Q.
Is the check result normal?
|
|
Repair the CAN bus line (Refer to GROUP 54C - Troubleshooting ).
|
|
|
|
Check if diagnosis code is set in the engine-ECU.
|
|
Q.
Is the diagnosis code set?
|
|
Troubleshoot the engine (Refer to GROUP 13A - Troubleshooting <4G6>,
GROUP 13B - Troubleshooting <4D5> or
GROUP 13C - Troubleshooting <4N1>).
Complete the engine troubleshooting, and then go to Step 6.
|
|
|
|
Check the vehicle speed signal data list of engine-ECU.
|
|
Item No.4: Vehicle speed signal (Refer to GROUP 13A - Data list reference table <4G6>,
GROUP 13B - Data list reference table <4D5> or
GROUP 13C - Data list reference table <4N1>).
|
|
Q.
Is the check result normal?
|
|
Troubleshoot the engine (Refer to GROUP 13A - Troubleshooting <4G6>,
GROUP 13B - Troubleshooting <4D5> or
GROUP 13C - Troubleshooting <4N1>).
Complete the engine troubleshooting.
|
|
|
|
(1)Connect the M.U.T.-III to the diagnosis connector.
|
|
(2)Use the M.U.T.-III to enter simulated vehicle speed.
- Item No.1: Speedometer (Refer to
.)
OK: The speedometer shows that simulated vehicle speed.
|
|
Q.
Is the check result normal?
|
|
Replace combination meter (Refer to ), then go to
Step 6.
|
|
|
|
- Item 4: Pointer (AUTO) (Refer to
).
|
|
Q.
Is the check result normal?
|
|
Replace the combination meter (Refer to ), and then
go to Step 6.
|
|
|
|
Check that the speedometer works normally.
|
|
Q.
Is the check result normal?
|
|
The procedure is complete. (If no malfunctions are found in all steps, an intermittent
malfunction is suspected. Refer to GROUP 00 / How to Cope with Intermittent Malfunction ).
|
|
|