Code No.U0114 Transfer-ECU CAN timeout
caution |
- If diagnosis code U0114 is set in the combination meter, always diagnose the CAN bus lines.
- Whenever the ECU is replaced, ensure that the communication circuit is normal.
|
TROUBLE JUDGEMENT
The combination meter sets diagnosis code No.U0114 when it cannot receive signals from the Transfer-ECU.
JUDGEMENT CRITERIA
With the ignition switch is at ON position, diagnosis code No. U1190 is not set and diagnosis code No. U1195 is not set, if the communication with Transfer-ECU cannot be established for 2500 ms or more, the combination meter determines that a problem has occurred.
PROBABLE CAUSES
- Damaged harness wires and connectors
- Malfunction of Transfer-ECU
- Malfunction of combination meter
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-III CAN bus diagnostics
Use the M.U.T.-III to diagnose the CAN bus lines.
Q.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting
).
STEP 2. M.U.T.-III other system diagnosis code
Check whether the SS4/ES4 system diagnosis codes are set or not.
Q.
Is the diagnosis code set?
Diagnose the SS4/ES4 system (GROUP 22A - Troubleshooting
).
Go to Step 3.
STEP 3. M.U.T.-III other system diagnosis code
Check if a diagnosis code, which relates to CAN communication-linked systems below, is set.
Engine-ECU
- Code No.U0114: Transfer-ECU time-out diagnosis code
Q.
Is the diagnosis code set?
Go to Step 4.
Go to Step 5.
STEP 4. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch to "ON" position.
|
|
(3)On completion, check that the diagnosis code is not set again.
|
Q.
Is the diagnosis code set?
Replace Transfer-ECU (Refer to GROUP 22A - Transfer-ECU
<M/T> or GROUP 23A - Transfer-ECU
<A/T>) and then go to Step 6.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the Transfer-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points
).
STEP 5. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch to "ON" position.
|
|
(3)On completion, check that the diagnosis code is not set again.
|
Q.
Is the diagnosis code set?
Replace combination meter (Refer to
) and then go to Step 6.
A poor connection, open circuit or other intermittent malfunction is present in the CAN bus lines between the A/T-ECU and the combination meter (Refer to GROUP 00 - How to use troubleshooting/Inspection Service Points
).
STEP 6. Check whether the diagnosis code is set again.
Recheck if the diagnosis code is set.
|
(1)Erase the diagnosis code.
|
|
(2)Turn the ignition switch to "ON" position.
|
|
(3)On completion, check that the diagnosis code is not set again.
|
Q.
Is the diagnosis code set?
Go to Step 1.
The procedure is complete.